Hello, Everyone! I am an embedded systems engineer, PCB designer, and firmware developer with over 10 years of professional experience. I provide complete, end-to-end solutions for a wide range of ele... Read more

Hello, Everyone! I am an embedded systems engineer, PCB designer, and firmware developer with over 10 years of professional experience. I provide complete, end-to-end solutions for a wide range of electronic device designs, supporting clients from initial concept and schematic design to PCB layout, prototyping, assembly, and full system testing. I have strong expertise in high-speed PCB design, including PCIe and DDR4 routing, as well as precise impedance matching for reliable performance at high frequencies. I also specialize in RF and antenna design for modern IoT devices, ensuring optimal signal integrity and system efficiency. In addition, I have deep experience in ultra-low power design, achieving microamp and sub-microamp current consumption for battery-operated and wearable systems. I specialize in firmware development for LTE-GPS-LoRa-BLE-based embedded systems (nRF52 series), including low-power optimization and high-precision sensor acquisition. My focus is on delivering robust, production-ready solutions with high reliability and performance. 🔥 Main Skills 👉Embedded Systems 👉Schematic Circuit Design(Low Power consumption Design) 👉Firmware Development(All Microcontrollers-STM32, TMS320, ESP32, FPGA, nRF52, Raspberry PI) 👉PCB Design(High speed signal routing, PCIe, DDR4, 18 multi-Layers Design, RF antenna Design,) using Altium Designer, KiCad, EasyEDA, Fusion 360(No problem in DFM-JLCPCB) 👉IoT with nRF52(BLE), LoRa(for example, SX1262), LTE(SIM card interface), GPS and other variety of sensors 🛠️Tools & Technologies: 👉 nRF5 SDK / nRF Connect SDK 👉SEGGER Embedded Studio + J-Link debugging 👉 C/C++ (bare-metal & RTOS) 👉 BLE GATT, LTE AT commanders, custom wireless protocols 👉SPI / I2C / UART / ADC integration 👉Low-noise measurement systems (nA level) 👉STM32CubeIDE, Cube MX, Keil, CCS, Arduino, ... 👉MQTT, Free RTOS, Zephyr RTOS 🚀 I can support your project from concept to production.

A master’s graduate with First Class Honours in Advanced Mechanical Engineering from University of Leicester, United Kingdom. During my masters, I had a module based on CAD modelling using Solid Works... Read more

A master’s graduate with First Class Honours in Advanced Mechanical Engineering from University of Leicester, United Kingdom. During my masters, I had a module based on CAD modelling using Solid Works, where I had successfully submitted a CAD model of an spur gear. Also, had carried out stress analysis on the modelled part. This module has given me an overall proficiency of SolidWorks and capability to work on any task individually. At the same time, I have hands on experience with Matlab. I have successfully presented many Matlab simulated programs using various programming algorithms. For my masters project which was based on ‘Co-deposition of nickel-SiC using Pulse reverse plating techniques to produce nano composites’. Majority of the work was undertaken at the university which made me utilize all the resources and advanced technological equipment like scanning electron microscopy. After course completion, I have worked as a Teaching Assistant in the department of engineering. I have assisted in demonstrating mechanical oriented first year labs concerning flow measurements in pipes, and electrical oriented labs based on circuit design and analysis using P Spice. Also, assisted in second year labs helping students to learn about material selection in devices using CES Edupack software, as well as different engineering materials micro structural properties and processing. Furthermore, I have helped in for fourth year module involving conceptual design process for turbofan engines with improvements in aero engine design configurations. Throughout my educational & professional experiences, I have built a rigorous tendency to achieve the best possible results by approaching them with new innovative ideas.