Timing pulley - SolidWorks Designer

Contest Closed
Description:
very simple timing pulley.
First to summit the complete work will get the prize.
Wants:
follow closely to the attach files.
specially the summit work page.
Don't Wants:
put your reference on the files
Software:
  1. SolidWorks (2012)

Entries

#1 timing pulley by studio sw
30 50 and 60 teeth timing pulley
more
2013-01-20 18:51:15

Discussion

No Comments Submitted Yet.

Similar Contests on Cad Crowd

Outdoor TV Enclosure
Design an outdoor TV Enclosure for 32" flat screen TV to be used outdoor such as backyard, pool, or cafeteria. - Inside the enclosure will hold flat screen TV with dimension of 30" x 18" x 2" (W x H x D). Dept can be extended if needed. - TV must be safely secure inside the enclosure when not attach to the VESA Wall mount - Must be able to mount with VESA Wall mount standard of 200mm x 200mm - Water resistant but does not need to be completely waterproofed - Have a cooling system, either ventilation for airflow (Fans) or cool down liquid (Freon) - A sound bar will be located in the bottom of the enclosure - Would be nice if the enclosure has feet that can be pushed in or pulled out when place on the ground to keep it balance.
J-shape
3D modeling of a J-shaped massage tool, much like a Theracane only smaller in dimensions. The tool should be modeled as close as possible to the attached images. The straight portion of the J-shape is approximately 10 inches long and 3/8in in diameter. The hook portion of the tool should form an approximately 180 degree arc and terminate in spherical end of 9/16in diameter. The handle, at the top of the J-shape, should be approximately 3/4in in diameter. The attached jpg images are of the actual tool that I would like modeled and should give you a good idea of it's dimensions. The png file should also provide a good reference. Thanks.
Mechanical Engineer to develop light guides or light pipes used with LEDs
Looking for an engineer that has experience with light guides or light pipes used with LEDs, and that can design a few simple light guides for an electronic device. 3 LEDs - red, green, blue will feed the light pipe. the other end of the light pipe will be visible to the user thorugh a cutout in the enclosure. the user will see this end of the light pipe, which is 2 strips each at .2 wide x 2" long. there may be some curvature to these 2" long strips (maybe a radius of 2.5"). when the red LED is on the strips will light up red. same for green, etc. need to make sure the lighting is continuous (not brighter at one end than the other). Proven experience with LIght pipes is required. $100 for initial sketch and background proving that this design will work. Further work would then be given to winner to develop the concept into a injection molded part. Good Luck and I look forward to working with you.
Liver Shell
Design should be of a liver shell. It should be an anatomically accurate model that can be printed if needed to. The inside should be hallow and the liver should include a hole on top where the hyper-vein would normally be and a hole on bottom where the vein would leave. The liver shell should be a 2 piece design that can be clicked/ screwed together to symmetrically put together the 2 halves. http://www.exchange3d.com/3D-Model-of-Liver-Anatomy/prod_28235.html#preview A more simplified version of this will be perfect.
Smart Wristband
I'm a tech&des student in the UK. I've been able to get by without being great at CAD but this year is unavoidable. My project is a wristband designed for old people that can track where they are and their heart rate. This project will be straight forward for anyone familiar with solid works 2013, neeed it by the next 2 days, (due on wed)