Description:Looking for an electrical engineer to build a working prototype of a portable, pre-natal ultrasound scanner that runs off a smart phone App. Combine an existing medical grade ultrasonic sensor (specifications attached) with your designed PCB and a functional App to build a proof of concept. Looking for a very low bill of materials cost. Minimum acceptable BOM cost is $100.
Wants:1. Bill of material cost.
Don't Wants:At this point, we don't care about;
1. Exterior product design (ie. we don't care what it looks like, we just want it to work).
2. App Design (again, we don't care about UI / UX, we just need it to work).
Ask for Sample:A functional, working prototype will be needed for this contest.
No Entries Submitted Yet.
Similar Contests on Cad Crowd
PLASTIC CASE DESIGN CONSUMER ELECTRONICS - Freelance CAD Designer
Design of new IR TV remote mostly concluded, I need expert to develop CADs for this device including small slide out drawer for a keyboard.. All culminating in SLA prototypes. Experience in consumer electronics would extremely helpful!!
We need to design a system that will place the sensor in the pipe in the direction of waste flow; Transmit from the sensor unit by WiFi, BLE, or Zigbee. Fire the sensor every hour or so - blockages usually build up over long periods of time Send readings back to the server for processing On setup, the pipe should be free of any blockages. Analyze the reading over a couple of weeks to build a nominal response for this pipe assembly. Compare later readings against the nominal response, if the readings are different and getting more different (the blockage is backing up more) then notify that there is a blockage.
PowerCube Product Design Contest for AutoCAD Designer
A new fashionable charging cable
STM32 Based Embedded Board
150mm by 150mm 4 layer board .
Huber electrical control panel design
we would like our current design which uses the Autocad mech. software to be converted to autocad elec. 2013 format and to the layout shown in the new design format