All in One Measuring Cup
in
3D Printing Design
held by
Gmac
Last seen:
2013-10-22 21:57:47
Contest Ended, Winner(s) have been selected.
Prepaid PrizeEntries
1st Winner
#8 : All in One Measuring Cup - Final edition
by Antanas
1. Outer diameter increased 2 mm (wall thickened to 4 mm);
2. Knobs on the flat plate increased and reinforced, and to make the correct shape.
2. Knobs on the flat plate increased and reinforced, and to make the correct shape.
Feb 7, 2013 11:38
#2 All in One Measuring Cup
by Antanas
All in One Measuring Cup. FULL parametrically SolidWorks model - You can change all the dimensions and notes!
Feb 1, 2013 10:48
#4 All in One Measuring Cup in .IGS format
by Antanas
the depth of the numbers 0.6mm, model in .IGS format
Feb 4, 2013 7:14
#1 Cup design
by Catalin
Was made in a rush and i have no ideea if is what you want but from the low resolution photo that you have posted is al i can make. If you have some data of the curved channels inside the outer cup please post them. If you only need the 3d file for renderings or what ever and you don't need exact dimensions the design i submitted should be enough. Best regards and good luck
Feb 1, 2013 8:39
#7 All in One Measuring Cup with working of cup animation done in solidworks motion analysis
by Ravinder Saggam
http://www.youtube.com/watch?v=O5H3oJajqLk
Watch above link for working of measuring cup animation done in solid works motion analysis
Watch above link for working of measuring cup animation done in solid works motion analysis
Feb 6, 2013 7:55
#9 All in One Measuring Cup
by Antanas
Separate parts in .IGES format... good luck
Feb 12, 2013 7:38
Discussion
diameter of about 2 1/2 inches. Volume is 1 cup (237mL) Handle 3 inches
attachment 3d2 shows a few measurements
thickness of material not too big of a concern
attachment 3d2 shows a few measurements
thickness of material not too big of a concern
any specific thickness of material? diameter? etc
any particular amout of "inches"?
added new attachment and additional information
they are quite fundamental if you want a measuring cup. also, which units would you like on the cup?
do you have dimensions please?
What are the dimensions and what is measured in units of volume?
Similar Contests on Cad Crowd
darnelius hill - Plastic Crate Rendering with SolidWorks
plastic crate
THE AFRO PICK - CAD Designer to Create 3D Design for Shapeways Print
I want to make myself an afro pick that instead of a black power fist it has an afro. I want to make it using shapeways.com 3D printing.
Rubik's cube shaped like a storm trooper helmet - freelance CAD designer
Want a simple 4x4 Rubik's cube in shape of a storm trooper helmet.
Thumb Peeler
Use this so peels of fruit come off in one full half-section without the nuisance of small peeling sections that can take a lot of time.
pocket box 2
Place lid on container via living hendge< so it can open up clam style
Gmac
Buyer