pocket box 2

Contest Closed
Description:
Place lid on container via living hendge< so it can open up clam style
Wants:
be open with your designs Its hard to pick a winner when everbodys the same. Be different ok. And make the units in all colors to show contrast. lets get ready and go. Good Luck!!
Don't Wants:
the container has four sides on the front we want our logo (The Jewel Washer) slanted in raised letters on the entrier front. and the background smooth finish type. no squares on the front wher the contanier opens and close
Ask for Sample:
yes
Software:
  1. SolidWorks

Entries

#3 Pocket Box 2_V2 by NPRG_3D
Aug 30, 2013 17:00
#2 Pocket Box 2 by NPRG_3D
Aug 21, 2013 21:15
#1 Improvement clamp Pocket box by rif
Improvement clamp Pocket box
more
Aug 14, 2013 1:14

Discussion

Thu, 15 Aug 2013 11:38:41 +0000
can i submit .igs or .step format as i dont use solidworks?
Thu, 01 Aug 2013 17:50:35 +0000
Do you have something you can send in regards to the Logo you want on here?
What side do you consider the front? Short side or Long side?
Would you want the Logo on the lid as well?

Similar Contests on Cad Crowd

Simple Wristband Attachment Accessory
This contest is to design a very simple wristband attachment accessory piece that can hold a piece of fabric that was cut in a circle. The overall shape of the piece is a football/oval shape. I am attaching some pictures to show a prototype that I made out of paper. There should be 2 triangle shaped holes on the 2 ends that I can attach the piece to. There should also be an inner circle where I can glue the circle cut of fabric. The inner circle should be indented about a millimeter inward from the flat surface to place the cut of fabric. The inner circle should also be 1/2 inches in diameter. There should also be an outline around that inner circle that is flat with the front surface and that outline circle should be a diameter that is about 6 millimeters wider than the inner circle. The overall piece should be about 1.25-1.5 inches long in width from end to end and about 5/8 inches in height from the tallest point in the middle of the piece. All of these measurement can be changed if needed to make the design better, but the inner piece that fits that fabric should be able to comfortably fit a piece of fabric that is 1/2 inches in diameter.
Headband
I'm hoping this is a simple project. I have designed a headband (a variation of the coil soccer headband worn by the likes of David Beckham). This one is for the ladies. The coil (unlike the soccer headband) becomes larger at the crown of the head. I will produce it through 3D printing for myself and friends - so far this is just a personal project. Specs are in the attached jpg.
Rosh
A small, rectangle tag, with a logo on it, and a hole on one side.
childrens playground
childrens playground, just a simple base with 3 activities, a slide off of one side, a tunnel slide off the other, and a pole with two swings off the other.
Design children's bedroom accessories
make 3d designs of children's bedroom interiors. design a door handle and a coat hook. Can use any software you prefer.