CAD drafting of industrial warehouses

Contest Ended, Winner(s) have been selected.
Description:
We have an aerial photo of the property, 2 buildings and 2 apartments attached to 1 of them as well as a sketch drawn by hand with dimensions. We need total of 5 CAD plans.
-a site plan (1pc)
-each individual buildings in a separate file (3pcs)
-All buildings and apartments on one file (1pc)

Each file in CAD & PDF
Wants:
Must have an experience.
Software:
  1. Any

Entries

#1 CAD for Industrial Warehouses by Caddude
I had a few questions on some of these but please look them over and get back to me and I'll change as needed.
more
Feb 4, 2014 16:23
#3 CAD drafting of industrial warehouses by CAD SPARKLES
CAD drafting of industrial warehouses
more
Feb 6, 2014 18:58
#4 CAD drafting of industrial warehouses by AbdoDesigners
Hello Sir, i will upload the rest of the files tomorrow.
more
Feb 11, 2014 0:00
#6 site plan revised by NickVal
Feb 11, 2014 1:54

Discussion

Wed, 12 Feb 2014 19:20:18 +0000
I will try my best
Wed, 12 Feb 2014 19:19:59 +0000
I will try my best
Thu, 06 Feb 2014 15:35:26 +0000
I would love to submit something, but I really can't read your sketch.
Sorry.
Wed, 05 Feb 2014 15:46:25 +0000
I would charge as much as $3000.00 for such a project. I'm sorry if this seems outrageous,
but architecture involves a lot of time if it is done properly.

Similar Contests on Cad Crowd

A research in annular plate
The work on annular circular thin plates is to develop and use the Galerkin variational method to solve the flexural problem involving annular circular plates. A second branch of the work would be to solve the same problem using the Least squares weighted residual techniques.
ahmet
makina imalat
Shoe design
I am looking to explore the idea of "reinventing" shoes. I'm looking to create a shoe that turns from a heel to a flat. In order to do so i need a mechanism for the heel to flip out and lock into place from a groove on the sole of the shoe. The heel itself would be based on a lever where you can push the heel into a groove of the bottom of the shoe to make the shoe a flat. Then click it out using a very simple unlocking system on the sides of the shoe ( a bit like when you unclick the lid of a calpol bottle pressing on both sides) to make it into a heel.
drawings
I have the 3d model but I need plsns, sections , axonometric diagram ( part to whole, circulation, sun direction, mass, unit, etc.) parking level , ground floor with unit detail, 2 sections, 2 perspective drawings , ((renderings)) of the interior and exterior.
Industrial Safety Glove Design
TPR (Thermoplastic Rubber) Protection Zones for Work Gloves We are an industrial work glove manufacturer and one of our main products are gloves with TPR moulded zones which are applied to the back of gloves (either sonic/heat or sewn) to provide protection from knocks, bumps, bangs, compressions etc. Gloves are widely used in the offshore Oil and Gas sector along with mining and automotive sectors. The TPR zones are primarily to protect the fingers, knuckles and metacarpals within the hand – see attached image. We have several mould designs already, attached are two samples TPR1 and TPR2 and we are looking at a new mould also attached named Karbonhex which is based on an Hexagonal pattern/design – the inner hexagonal design is okay but the actual outer/outline needs a redesign to also make it more hexagonal…. This is as much about esthetics as functionality!