Wall angle

in 3D Modeling Design held by Andrea
Contest Closed
Description:
This is a prototype of a wall angle, I need autocad drawings to manufacture this piece.
Wants:
Not sure about this item, this project is very simple and small.
Ask for Sample:
I believe the project is too little to be completed in two phases.
Software:
  1. AutoCAD

Entries

#1 Special corner Trim by Three Axis
Jul 26, 2013 4:58

Discussion

No Comments Submitted Yet.

Similar Contests on Cad Crowd

2014 Burning Man Mutant Vehicle Project
Concept designs for 2014 Burning Man Mutant Vehicle Project based on 26’ GMC Motorhome with a stegosaurus appearance. Design must radically alter the exterior of the base unit while minimizing the costs and difficultly of the alterations. Winning design will move forward to more work on mechanical design for the build out.
J-shape
3D modeling of a J-shaped massage tool, much like a Theracane only smaller in dimensions. The tool should be modeled as close as possible to the attached images. The straight portion of the J-shape is approximately 10 inches long and 3/8in in diameter. The hook portion of the tool should form an approximately 180 degree arc and terminate in spherical end of 9/16in diameter. The handle, at the top of the J-shape, should be approximately 3/4in in diameter. The attached jpg images are of the actual tool that I would like modeled and should give you a good idea of it's dimensions. The png file should also provide a good reference. Thanks.
A complex helix for visualising a pedagogic hypothesis
The spiral of learning (Kolb & Kolb) is a simple helix visualising the learner's progress. I need to visualise a more complex spiral. Turns on this helix are circular. Each turn represents an interaction between teacher and learner. This helix contains 1 grand turn. A grand turn contains at least 3 smaller turns. This creates a turn complex. Each turn achieves a small or large rise on the z axis depending on the diameter of the turns on the x and y axes. In elevation view the turn complex should have a stepped appearance due to the presence of the smaller turns, with the lowest steps at left and the highest at right. The idea to be communicated is that the larger turns contain at least 3-5 smaller turns. Each turn achieves a small increase in z-height as the learner exits the turn, like freeway traffic using a cloverleaf junction. Multiple interactive turns aggregate to a large gain in z-height. In the attached illustration, the largest loop should be understood as not a part of the visualisation. I would like to see two variations of the design: (1) smaller turns ranged on outside of grand turn diameter (2) smaller turns ranged on inside of grand turn diameter.
Basic Project
I have a project for you. Contact on 9831039592
3D iPhone 6s Plus case
One piece composite iPhone case. Interior will be a rubber type material with a polycarbonate shell. The material will be bonded together with tabs and mechanical fasteners. The provided material is prettt limited, just a basic sketch but will work with the person to nail down the design.