Discussion
From one of our managers:
- The micro USB port should be on the back in a channel, thus allowing both routing the USC cable invisible through the ceiling tile, or exit to the side.
- The design should also allow to place or mount it on a desk, this means the back surface must be flat, but can have a screw hole, channels, deepening for mounting and USB connection
- The micro USB port should be on the back in a channel, thus allowing both routing the USC cable invisible through the ceiling tile, or exit to the side.
- The design should also allow to place or mount it on a desk, this means the back surface must be flat, but can have a screw hole, channels, deepening for mounting and USB connection
the final product shall not resemble or be mistaken for a camera in any way. thank you.
Unfortunately the pcb layout is not complete. The antenna will rise from the center of the pcb.
Can you share the pcb layout for the better idea.
I can make a Injection mold, when You have 3D model of the part, that You want. I can prepare all documentation, that You need, with all 3D models, parts, 3D Assemblies and drawings.
Hi Akash. The antenna can be inside the housing. From the outside it does not need to resemble an antenna. The length of the antenna is what determines the height of the housing. You have 2 options as described. Thank you.
OK I&
;ve understood it.
;ve understood it.
I&;m just trying to understand the antenna, so it should hanging down perpendicular towards the floor... So what the housing should be on a slightly raised base?
;m just trying to understand the antenna, so it should hanging down perpendicular towards the floor... So what the housing should be on a slightly raised base?
TD
Buyer