#26 Shot Glass v1 by neegyus
I've submited in the most common formats for injection molding.
Please pay attention to thickness on the thread zone (i was trying to make it more appealling and it is feasable, but depends on the material to be used). Also, you should decide how is it going to be made (injection mold wise) - the automatic unscrewing is expensive, the manual unscrewing gives too much man labor, and colapsible cores would imply design changes.
2013-03-20 01:20:19
#29 Shot Glass v3 by neegyus
Here'as another model. This is an litle improvement to my v1. I like to do the models without the inside lump on the thread area (just like it more). There's also some clearance on the threads (minimal - check the 3D), that are suposed to allow a better functionality and tightening.
If you would like any other format, I think I can provide it for you, except the Autocad (don't work with it).
2013-03-22 01:08:48
#27 Shot Glass v2 by neegyus
This is another option in wich the thickness is maintained in the thread area and the bottom waves are diferent.
2013-03-21 00:22:58


No Feedbacks Yet.