Job PCB design — RS-485 carrier board for a Pico-form Ethernet module (2-layer)
Pico-form-factor Ethernet module and adds a 3.3 V RS-485 interface and a 12 V power input. Roughly 25 components, 2 layers, no controlled impedance, no high-speed routing. The MCU, flash, crystals, Ethernet PHY
Kicad PCB Layout Schematic Capture BOM Creation Analog Electronics Design Altium Designer EasyEDA CAD Design PCB Design Services Electronic Prototyping and Design Services 3D Design Services
3D Model ARM MICROCONTROLLER BOARD
STM32F407ZGT6 CORTEX-M4 MICROCONTROLLER BOARD WITH ETHERNET, USB HOST, USB-OTG, SD-CARD
Designer divyagoel
Hardware designer
Hardware Design Engineer I have strong experience in High-Speed PCB design, ESP32 microcontrollers, Ethernet, GSM , LoRa and Digital/Analog electronics. I am also skilled in using Altium Designer and working
Altium Designer Design Engineer Electrical Circuit Design Services Electrical Engineering Electrical Schematic Drawing Services Electronics Design Service Embedded Hardware Design ESP32 Development Firmware Developers High-Speed PCB Design Internet of Things (IoT) IoT Hardware Design Microcontrollers PCB Design PCB Design Services Programming Prototype Design Engineering
3D Model System Control board - 4L
Designed a 4 layers system control using an ATSAM4E MCU with Ethernet, USB, RS-485, SPI, and I²C interfaces,
Designer quintonr
Full stack embedded engineer
topology, power sequencing, clocking, isolated I/O, sensors, motor control - Interfaces: Ethernet/IP, Ethernet, SPI, I2C, UART, RS232, USB, LVDS, MIPI, industrial I/O, cable/harness documentation - FPGA
BOM CAD Design OrCAD SAP
3D Model esp32_pcb_board
designed esp32 base industrial board with GSM, ESP32 S3, 12/24V digital IO, 12V 12-bit ADC, DAC, Ethernet and DC-DC converter
3D Model Custom i.MX Industrial SBC, 10-Layer DDR Design
specific I/O mix (Ethernet, RS-485, CAN, USB) that commercial industrial boards didn't offer at a reasonable cost. Solution: Custom SBC around the NXP i.MX with DDR, Gigabit Ethernet, USB, and expansion
3D Model PoE Indoor Asset Tracker with BLE Tag Scanning
Challenge: Real-time indoor asset tracking across a large facility. The client wanted to use existing Ethernet infrastructure: no new power runs, no battery-powered units to maintain. Solution: PoE-powered monitor
3D Model PCB Design of Super Computer Mainboard and Embedded Devices
Super-Computer Mainboard. - 24Gbps PCIe Gen4, 12Gbps PCIe Gen3, DDR4 DIMM, SSD, SATA, - HDMI, USB3.1, 100MHz Ethernet, SD Card, DVI, VGA, - SPI, UART, RS485, RS232, I2C) The PCB Design of Large-Scale Broadcasting System
Service I will design schematic, PCB, gerber, BOM, manufacture, and high speed for DFM
- 24Gbps PCIe Gen4, 12Gbps PCIe Gen3, DDR4 DIMM, SSD, SATA - HDMI, USB3.1, 100MHz Ethernet, SD Card, DVI, VGA - SPI, UART, RS485, RS232, I2C 2. The PCB Design of Large-Scale Broadcasting
PCB Layout Design PCB Engineering PCB Manufacturing digital Electronics Design PCB Design PCB Fabrication Electronics Design Altium Designer PCB Design Services Electrical Engineering Electrical Circuit Design Services