Stylish Case for a Car Key Blind

We are a new venture specializing in the creation of Self-Heating Tumblers. Our tumblers (travel mugs) are quality made with precision and self-heat themselves by the press of a button. The button initiate a reaction inside the tumbler chambers, causing the interior to heat up. We are looking for a concept/prototype design in 3D. We have attached design specifications and photos describing the product.

We are looking to develop product design drawings to be used for manufacturing of our motion tracker unit, which will be launched for a fitness center chain, for tracking use of exercise machines. The unit will house our own electronic module and battery, so the design shall result in the required 3D production drawings for plastic molding of the unit housing (stp or dwg file format), which will be in two parts (top + bottom), and a matching holder. Detailed descriptions (dimensions and considerations) are enclosed in a separate document, to be considered as guidelines with some freedom for the designer.

I need a unique, rugged quadcopter UAV design,analysis and all necessary fabrication details for production in large quantities.The quadcopter should have a high endurance similar to the Microdrones Md4-1000 LINK: (http://www.microdrones.com/products/md4-1000/md4-1000-key-information.php#what) The quadcopter should be modular in nature like the Aeryon Scout LINK: Scout(http://ww1.prweb.com/prfiles/2010/09/01/3259734/MG1969.JPG) NEEDS: good aesthetic design,analysis along with all production details, modular nature, Materials used, Sourcing details, Bill of materials(BOM)

We are a new venture specializing in the creation of dual sided hair care products. Our first product is a double sided shampoo-conditioner bottle. The product is eco-friendly and saves money and space compared to buying separate bottles of shampoo and conditioner. We are looking for a concept/prototype design in 3D. We have attached a product design sketch and photos describing the two sided bottle and twist caps.

This is about a first product draft, which shall later be turned into a production ready design. I need an enclosure for a custom made electronic part. The rough form-factor should be similar to a navigation system (see attached files) with a display in front and parallel enclosure boundaries, slightly rounded edges. The display is 4.3 inches wide (see technical details attached) and should be included in the rendering. The enclosure should be 4 cm deep. As a bonus, the display shows attached bar diagram. At the back, there should be the possibility for a DIN rail mount, top hat rail EN 50022 – 35 × 7.5 but also for direct wall mount using screws or mounting to a bar with cable ties. At the front left side of the enclosure, I need a C14 inlet to add a power cable and a Schuko socket: https://en.wikipedia.org/wiki/Schuko or CEE 7/3 socket. See attached figure of the design. The material should be dark grey with a bit reflective surface. Please add our logo to the upper left corner of the front, below the display. If it fits optically, it could glow a bit in green.