iPhone Audio Accessory - Music Booster

3D model a watertight locking iPhone case, for each sized iPhone, that is designed to discourage iPhone users from using their phone too often.

We want a lockable dog leads clip design for manufacturing. The dog leads are attached by the clips attached to the D-ring of the dog collar. There are many locking mechanisms in the market e.g. carabiner, twist-to-lock... We need a unique design that is differentiated from the market. It needs to use single-handedly and is easy to use for dog owners.

This project is to design the housing for a motion detector for commercial office buildings. it should be approximately 2.5-3.0 inch circle and the body should be no more than 1.0 inch thick. the circle can be bigger if the edges sweep out to with a nice curve back to the ceiling surface. it will mount to a standard t-bar ceiling grid. (the kind of ceiling with the drop in tiles) it should mount in the corner of a light fixture with a portion of the "top" or up facing side exposed to the light fixture. and have a window on the top that looks up at the light... (for a light sensor) the window shall be rectangle and dimensions are: 33.0×10.8mm. the face which points to the room shall have a PIR lens (like this one http://www.jvs.de/Carclo_Fresnel/Drawings/PF68_12076_Drawing.pdf i'd like to receive drawings that are 3d printer ready. ease of mass production and tooling should be considered. drawings should also be open for editing by our team. Our team will add the holders, screws, clips, etc for the Electronics inside. the mounting method could be a small piece of spring steel or plastic. White plastic/PC examples: http://cdn3.volusion.com/jn7vt.cfos2/v/vspfiles/photos/HBL3-2.jpg?1416706843

Would like a prairie style modern home roof and exterior design based on floor plans. May be creative and please MUST use Chief Architect software. I have version X5 and X6. I have attached pictures of examples of what we are looking for. Please incorporate: -30" overhangs -Low pitch - Raised Entry -Raised Rear Deck

Looking for someone to design a concept ecig and then into in to real life 3d render of your design we would also require a 3d model to pass to the mechanical designer. This does not require any mechanical designs it's a concept only. The materials that will be used are black gloss Carbon Fibre as the outer casing tube, with a pattern cut out exposing a rose gold plated tube that can be seen throughout the cuts in the carbon. Other fittings like top & bottom covers, rings and bottom button in rose gold.