I am an Electrical & Electronics Engineer with hands-on experience in PCB design, AutoCAD electrical layouts, SolidWorks 3D modeling, and MATLAB/Simulink simulation. Over the past...
2D & 3D Mechanical Design2D & 3D Modeling Solidworks2D & 3D by Solidworks2D/3D AutoCAD16
more
Electrical | Low voltage ELV |Solar Energy | Expert Design Engineer
Algeria
Electrical | Low Voltage ELV | Solar System | Automation Solutions | Network | Telecommunication
Expert Design Engineer
I am a low voltage engineer with a strong focus on electric...
I am a CAD operator with a NICET IV certification in Fire Alarm Systems and an associate’s degree from ITT Tech in Computer-Aided Drafting and Design. Since 1998 I have had experie...
Mechanical Engineering, Drafting and Detailing & BIM Modeling Specialist
Dhaka,
Bangladesh
As a full time freelancer I offer wide range of CAD based engineering service. I am a mechanical engineer and have been working in Assembly Design, Part modeling, BIM system, Facto...
Mechanical Design Engineer | Expert in SolidWorks | 3D Modeling | 2D Drawing
Bandung,
Indonesia
Aeronautical Engineer and Mechanical Engineer with strong experience in UAV systems, mechanical–electrical design, and
the development of special-purpose industrial machines. Profi...
2D & 3D Mechanical Drawing2D & 3D Modeling Solidworks2D & 3D by Solidworks3D Modeling7
more
Experienced Solar PV Design Engineer proficient in modeling and analysis using PVsyst and SketchUp s
Karachi,
Pakistan
Electrical Engineer and PV Design Specialist with 2+ years of experience in solar PV system design. Proficient in using SketchUp and PVsyst to develop and optimize high-performance...
I’m an Electrical Engineer with a BS Electrical Engineering from NJIT and two years of RF and PCB design experience at General Motors. As a Wireless Hardware Engineer, I validate a...
18 years of experience in Revit modeling,
Proficiency in Revit have an in-depth understanding of the software's capabilities and functionalities.
MEP System Design: extensive exper...
I am an Automation Engineer, with three years of experience in PLC Programming, system design, GD&T, and 3D-printing.
I have designed and fabricated: circuit boards, end-of-arm to...
2D & 3D Engineering Design2D AutoCAD3D SolidworksAutoCAD9
more
