Parth S.

Experience

• Technical lead Confidential · Full-time Oct 2017 – Present 8 yrs 1 mos India  Proficient on working with “OrCAD Schematic Capture/PCB Designer 17.4”, “Mentor
  Graphics Xpedition VX2.8”, “Fablink” & “Mentor Graphics PADS” .
   Performing component placement in co-operation with mechanical and hardware
  developers.
   Working experience of communicating & co-coordinating with clients in order to
  understand the design requirement.
   Responsible for creating and verification of PCB Component footprint, CAM/Gerber
  review and verification. Also responsible for Creating PCB documents for Fabrication
  and assembly.
   Responsible for creating various constrains as per design requirement like physical,
  spacing, electrical & DFA/DFM/DFT.
   Working experience for DFM check in OrCAD PCB Editor and Valor NPI tool
   Experience on Blind-Buried via, Any Layer via stack up & back-drilling Technology.
   Experience of Designing PCB layout up to 28 Layers and minimum 0.35mm pitch BGA
  processor layout (Qualcomm QCS-660/820/410/610/6490).
   Experience of designing HDI PCB having thickness from 0.8mm to 4.2mm.
   The most compact PCB created having dimensions around 18mm x 20mm x 0.8mm with
  High complexity and Blind-buried technology.
   Worked on various interfaces like DDR, WLAN, USB3.0, HDMI, RF, MIPI CSI/DSI, SDC,
  Ethernet, PCIE, UART, SPI, I2C, DVP.
   Experience of handling PCB design as per processor’s SI and PDN requirements.
   Experience of design reuse for one PCB layout to another & within the same design.
   Experience of Simulating & Verifying Impedance for high-speed signals within a Allegro
  PCB editor.
   Experience of designing Flex-Rigid board layout.
   Worked on Layout & routing for various Qualcomm WLAN, GPS, and audio codec
  chipsets layout.
   Designed PCB layout having around 8500+ components and 26000+ connections single
  handed with critical timeline.
   Working experience of creating fabrication drawing in mentor graphics Fablink tool.
   Experience on reviewing the PCB layout & PCB deliverable
   Experience of handling manufacturing TQs.
   Going through Mentoring, guiding & resolving technical issues for junior engineers &
  other team mates.