Description:Need a 3d model of a tank that can be exported to a .stp file. The tanks will be 21mm from front of hull to back of hull.
Wants:Above average detail but not every nut and bolt needs to be shown. Detail for approx 1/285 scale pieces.
- Rhino, Inventor, Autocad, etc
Similar Contests on Cad Crowd
Crown Afro Hair Pick
Looking to design a new hair pick that has a simple but UNIQUE crown on the top of the handle, instead of the fist as seen in the example provided.
Clear Plastic Case
I am looking for a round clear plastic case design to be 3D printed for a prototype. This is very generic. The case should be 4.5 inches in diameter, round tapered off around the edge, and approximately 1 inch thick at the center, tapering off to about .25 inches until edges connect. The front and back should be of equal dimensions and attached by plastic and opens and closes, and snaps closed. The back should be black plasting, and the front should be clear plastic. This case would be very similar to something like a round eyelash case holder, or something that might hold ear buds.
I need to make dice candy so I need a 3D print out of dice that are 10 dice across and 10 dice high which will give me a 100 dice mold. I will pour food grade silicone around the 3d printout and use that for my candy mold. The file I have here for the dice is too large so I need it redrawn so that I can get the 3d mold made.
Moravian Star Tree Topper Mount
Resign of an existing mount. The original mount uses a 1" dowel - the new design is to use a 1/4" dowel. DAE, X3D, X3DB, X3DV, WRL
3D Printing Design | Meet the minimum thinkness on two small parts of my 3D STL file for Shapeways!
I need someone to make a certain part of my 3D anchor stl file a little thicker. Nothing complicated at all! The guy that was working on this file is really swamped with work and cannot complete this edit. This job should literally take less than 30 minutes if you know what you are doing. On the attached picture it shows that I need to make specific parts of the anchor a little thicker to meet the minimum supported wire thickness of .8mm. Here's what the email I recieved from shapeways said: "Here is why we cannot print your model: The minimum thickness for free/supporting wires > 1.0mm and supported wires > 0.8mm for this material. Please thicken the wires of the model." I have specified what needs to be done on the picture attached. Please message me if you need clarification. If you know what you are doing and have worked with stl. files and understand the thickness minimum that shapeways requires for 3d printing then this should be a no-brainer.