LP-13 Desk Lamp: Multi-Part Assembly with Tip-Over Stability Check (Concept Study)
Concept study (self-initiated, not client work).
An LED desk lamp: a steel base, an aluminium stem and arm, a zinc friction elbow, and an aluminium head with an LED board and diffuser.
Tip-over check, from the CAD
- The centre of mass comes from each part's CAD volume × density (plus 60 g for the cable and switch), with the arm fully out as the worst case.
- Rev A (moulded ABS base, Ø140): the CoM sits 34 mm outside the base, so it falls over.
- Rev B (Ø160 × 12 mm steel disc, 2.4 kg in total): the CoM stays 56 mm inside the edge, and the lamp only tips past 50° of tilt.
Deliverables: STEP assembly, stability calculation, and renders.
Software: FreeCAD, Blender.
Published