KB-12 Two-Shot Control Knob: PC/ABS Core with TPE Overmould, 2K Moulding Checks (Concept Study)

Concept study (self-initiated, not client work). A Ø36 mm control knob for an appliance or audio product, moulded in two shots: a rigid PC/ABS core, then a soft TPE grip band. 2K moulding checks, from the CAD - TPE is 1.6 mm thick everywhere (≥ 1.0 mm), so it fills without short shots. - The second-shot tool seals on 1.6 mm steel shut-off lands above and below the band, giving a clean edge with no flash. - The TPE flows through 8 windows in the core and locks mechanically, so it holds even where the TPE grade bonds weakly to PC/ABS. - The D-shaft bore (6 mm, 4.5 flat) can take about 1.9 N·m before the plastic yields, around 6× a typical knob's turning torque. - 16 % of the volume is TPE (2.9 g), which keeps cost down. Deliverables: STEP for both shots, checks, and renders. Software: FreeCAD, Blender.
product-design injection-molding overmolding tpe knob-design two-shot-molding