DC-15 Die-Cast Aluminium Housing: Cooling Fins, Draft Check and Thermal Estimate (Concept Study)

Concept study (self-initiated, not client work). An electronics housing die-cast in A380 aluminium, with cooling fins on the lid and a powder-coat finish. Die-casting checks, from the CAD - Walls have 1.5° draft and fins 2.0° per side. Only 1.3 % of the surface has no draft: the tapped holes (drilled after casting) and the cable-gland boss (one slide in the die). - Fin gap 5.4 mm, height 20 mm: a ratio of 3.7, inside the ≤ 4 guideline for cast fins. Thermal estimate - Outside area from the solid: 958 cm² finned vs 355 cm² plain. - In still air (h = 6 W/m²K, fin efficiency 0.9), it can shed about 21 W at a 40 K case rise, against 8 W for the plain box. This is an early sizing number; a thermal test would confirm it. Deliverables: STEP, draft and thermal checks, and renders. Software: FreeCAD, Blender.
aluminium die-casting dfm enclosure-design heat-sink thermal-design