Designs by Vitor Milani

For Project: Balloon Archery Target

Report Designer

#39 Balloon Archery Target_Rev01 by Vitor Milani
Based on your feedback, I refreshed my project: the holders became thinner and I changed the angle to became the deflection a bit better than before.The general concept is the same. If you have other concerns, please let me know.
Jan 6, 2015 20:06
#32 Balloon Archery Target by Vitor Milani
This projecy is based on two parts united by M4 bolt and nut. Both parts are similar, one has a housing for a nut, so its not needed to have two tools to tighten the bolt (the user will put the nut inside the housing and tighten ten bolt, fixing the both parts together, and the other part has a keyhole to hang it on the wall.
Both parts have some orifices to save material to save material while printing and they have a smooth angle to make it easier to fix the balloons and to save material without harm the structure.
Well I hope that you consider the technical aspects of my project.
Jan 6, 2015 2:54


Vitor Milani


Tue, 06 Jan 2015 19:22:15 +0000
Thanks for the feedback. I'm posting another revision considering your advises. I explain what I did in the description of the project.



Tue, 06 Jan 2015 06:23:00 +0000
Thanks for your entry, while I like the general concept, here are my concerns.

The head on profile looks a little wide. My concern is that arrows (with sharp tips) could easily damage the holder/device. Maybe consider either making the head on profile thinner or taper some of the thicker areas so that arrows deflect to the side.