Discussion

tsalpha

Designer

Thu, 15 Jan 2015 22:47:31 +0000
I was hoping to get a follow-up from you before this contest ends. I have several ideas I'd like to go over with you.
Thanks,Tom

zicked

Buyer

Fri, 09 Jan 2015 02:25:25 +0000
Thank you. I will follow up soon.

tsalpha

Designer

Thu, 08 Jan 2015 16:15:21 +0000
Looking forward to receiving your reply to this newest revision. I've also gone ahead and check the printing costs of each piece.
Center piece is $7.14 each in laser fused plastic, or $11.06 each in laser fused metallic plastic.
End hook is $2.34 each in laser fused plastic, or $2.92 each in laser fused metallic plastic.
Large balloon section is $3.94 each in laser fused plastic, or $5.64 each in laser fused metallic plastic.
Small balloon section is $4.71 each in laser fused plastic, or $6.90 each in laser fused metallic plastic.
A lot of consideration has been given to each part, for future injection molding tooling. Simplest possible tool for each item of this design will yield the lowest for the aluminum dies.
Thanks, Tom

tsalpha

Designer

Thu, 08 Jan 2015 00:49:23 +0000
Sounds like a great idea. I'll modify the current small balloon segment and create and end piece with any eye-hole. I've sent you 2 messages via the mail system here on Cadcrowd, not sure if you've received them. Thanks Again. Tom

zicked

Buyer

Wed, 07 Jan 2015 22:44:36 +0000
thank you. The only concern I have is the spikes. For many reasons (too many to go into now) I really need only one way to hang the device/holder. Maybe it can be an alternate modular piece that can go on the end of one of the arms.