#19 Home Autom Casing MT Concept-2A.zip Updated/revised. by Mauro
Update of concept-2.
Hi buyer.
Find attached an updated version of my Concept-2 as Rev-A.
I’m a little unclear as to what you require regarding power to the unit. You mentioned in your first brief the Micro-USB port will be used for this purpose, and latter you went to mention of a power jack to be included. I went with the first Micro-USB. If you want to change this, it can be updated latter.
Various caps / covers, can be designed & manufactured for the open connectors for snap fits.
Please note, there is a problem in my case alignment at the radii corners. I will have this corrected. I wanted to quickly get you guys a sample model for you to evaluate.
I hope to hear back from you soon with some feebback.
Kind regards
Mauro
more
2014-06-24 05:23:14
#14 Home Automation Casing MT Concept-2 by Mauro
2nd. Itteration submitted
more
2014-06-18 09:27:47
#5 Home Autom Casing MT Assy-1 by Mauro
I would love to get some feedback from you guys regarding my concept design. Note this model is fully parametric so modifications can be carried out quickly and efficiently.
For you reference we could use Autodesk 360 for any collaboration you need to conduct.
Cheers Mauro.
more
2014-06-12 01:28:44

Discussion

Mauro

Designer

Thu, 19 Jun 2014 10:20:59 +0000
Hi guys.
Regarding the on - off switch. Would you prefer it on the front i.e. where the camera is facing or elsewhere.
please note I have a push button already on the side in green 15 x 3mm in size.

Cheers
Mauro

Mauro

Designer

Thu, 19 Jun 2014 09:47:10 +0000
Hi buyer,
Thanks for liking my design. At least the exterior. I’m reasonable confident that all the internals will meet you requirements. As long as we are all on the same page.
You requested on your design brief for this product to have a “Sleek or Sexy look”.
I could give my design a Sleeker look by possibly making a minor change to the Camera P.C.B.. I’m not sure if this is an off the shelf item. Would it be possible to have the camera component closer to the top end of the board. i.e. the other end from the connecting cable. Therefore I can bring the camera board lower into the bottom case. This is so I can alter and lower a design feature of the top case, thus giving it a sleeker and sexier look. Smooth blending curves and subtle features often brings out the WOW factor. Don’t you think..?
I will get you an update on the model with all internal features in place to you A.S.A.P. I think it will have some similarities to my 1st. concept. i.e. for the internals.
Much Thanks.
Mauro
p.s. by the way could I know your name so I can address you by it in future correspondence.

inventca

Buyer

Thu, 19 Jun 2014 02:30:35 +0000
We mean that we liked concept-2.

inventca

Buyer

Thu, 19 Jun 2014 02:29:48 +0000
Hi Mauro,
This design looks much better and we like it from outside. Can you please add all three boards inside the casing? We need to make sure all the clearances and size. Also we need a power jack, push button switch for installation and infrared light pass through area. We do not see any connector openings and also mounting or clip for board/camera board, did you add those?
Thanks