Wall Mount EV Charger Enclosure – Die-Cast Housing, IP54 Electronics Enclosure Design, 3D CAD Model & Drawings (VOLT Concept)

Concept project: VOLT, a 7.4 kW wall-mount EV charger enclosure designed for manufacturing. Not a client product. What is in the model - Die-cast aluminium (AlSi10Mg) rear housing, 200 x 300 x 72 mm overall, on a 3 mm galvanised steel wall bracket held by four screws - Molded PC front cover (UV stable, 2.5 mm wall) with a clear light bar, held by four M4 screws into cast bosses - EPDM gasket on the 3 mm die-cast rim, squeezed 25% for IP54 - Main board, contactor and terminal block laid out inside - M25 cable gland at the bottom, output cable and a wall holster that docks the plug Design for manufacturing (DFM) - The housing is a simple cup with 1.5 degree draft inside and out, so it casts in a two-part die; only the gland hole is drilled after casting - Screw bosses are drafted cones that merge into the corner walls - The bracket goes on the wall first, then the unit hangs on it - One seal line: cover, gasket and rim, with the cable leaving downward through the gland Checked in CAD - 0.000 mm3 interference across 34 part pairs - Exact draft analysis: 99.4% of the die-cast housing drafted along its pull - 0.7 mm clearance all round between the plug nozzle and the holster bore Included - Hero render, exploded view, section with callouts, GA drawing (front + side) and three colourways Services this shows: EV charger enclosure design, electronics enclosure design, die casting design, aluminium die-cast housing, IP54 enclosure, injection molded cover, product design for manufacturing, DFM, 3D CAD modeling, technical drawings, product rendering.
die-casting electronics-enclosure dfm enclosure-design ev-charger ip54