Smart Thermostat Design – Smart Home Device, Injection Molded Housing, 3D CAD Model & Drawings (CIRRUS Concept)

Concept project: product design and 3D CAD model of a round smart thermostat, designed for injection molding and CNC turning. What is in the model: a wired wall plate with a terminal block and two screws, a molded PC chassis that clips onto the plate with three snap hooks, a turned 6061 aluminium ring that rotates on the chassis to set the temperature, a 53 mm round display behind a cover glass, a main board, and a magnet in the ring that passes a hall sensor on the board. 10 parts plus the wall. Design for manufacturing (DFM): - Wire the plate first: the terminal block sits on the wall plate, so the installer wires it and the unit snaps on. - One turned part: the ring is a single turned and anodised aluminium part with a pocket for the magnet. - No contacts in the ring: the magnet passes the hall sensor 4.6 mm away through the chassis wall. - The chassis cup is drafted 1 degree inside and out along its pull. Checked in CAD: - 0.000 mm3 interference across 21 part pairs. A clash between the magnet and the chassis was found and fixed by moving the magnet into the ring wall. - Exact draft analysis: 96.8% of the chassis at 1 degree or more. - 0.4 mm running gap between the ring and the chassis. Included: product render, exploded view, section view, GA drawing with dimensions, annotated section and three colourways (silver, brass, graphite). Services this shows: smart home product design, consumer electronics enclosure, plastic part design, CNC part design, DFM review, 3D product rendering.
injection-molding dfm consumer-electronics smart-home thermostat