Sheet Metal Design – Aluminium SBC Chassis, Flat Pattern & Bend Table, Laser Cut (DECK Concept)

Concept project: a mounting chassis for a single-board computer and an SSD, made from one laser-cut aluminium blank and six press-brake bends. No welds, no extra brackets. What is in the model - 1 blank and 8 PEM standoffs, 140 × 100 × 35 mm, 124 g - 5052-H32 aluminium, 1.5 mm - 6 × 90° bends, R1.5 inside - Flat pattern 204.8 × 194.6 mm Design for manufacturing (DFM) - One blank, six bends: one laser job, one brake setup - Every hole and cut-out at least 2T + R = 4.5 mm from a bend tangent (the check moved the flange slots out) - Press-in M2.5 PEM standoffs hold the SBC and SSD: no loose nuts, no tapping 1.5 mm sheet - Ø3 corner reliefs, so the corners fold without tearing Checked in CAD - K-factor 0.44, bend allowance 3.39 mm for 5052 air bending - Every edge at least 4.5 mm from a bend; the tightest is the I/O window at 5.0 mm - 0.000 mm³ interference between SBC, ports, SSD, grommet and chassis Included: STEP file, the flat pattern and a drawing with the bend table. Services this shows: sheet metal design, flat pattern and bend table, laser cutting and press brake, electronic enclosure design, manufacturing drawings, DFM review.
aluminium chassis sheet-metal laser-cutting flat-pattern