Rugged IP65 Enclosure – LoRa GPS Tracker Housing, O-Ring Seal, Injection Molded (TRAIL Concept)

Concept project: a sealed two-shell housing for an off-grid LoRa + GPS tracker. The antenna layout was planned first, so the GPS gets a clear view of the sky and the LoRa feed sits at the far end. What is in the model - 2 shells plus seal, button and port plug, 92 × 56 × 32 mm - PC/ABS, UV-stabilised, injection molded - Ø1.6 silicone cord seal, IP65 target - 4 × M2.5 screws into heat-set inserts Design for manufacturing (DFM) - O-ring cord in a 1.15 mm deep groove: 28% squeeze, 87% groove fill, cheaper than an overmolded gasket - GPS patch and LoRa SMA bulkhead at opposite ends, 58 mm apart - D-hole for the SMA stops it spinning when the nut is torqued; a spot face seats its O-ring - USB-C sits below the seal line, so the gasket runs unbroken all the way round Checked in CAD - 0.000 mm³ interference between shells, seal, PCB, battery, button, SMA and screws - 10.5 mm metal clearance: no insert or screw within 10 mm of the GPS patch Included: STEP files for top, base and assembly, ready for tooling quotes. Services this shows: electronic enclosure design, waterproof IP65 housing, IoT device enclosure, O-ring and gasket design, injection molding design, DFM review.
ip65 iot-device gps-tracker waterproof-enclosure gasket-design