BRISK sealed sonic toothbrush: no openings, inductive charging (concept)

Concept project: a waterproof sonic toothbrush whose handle has no openings at all. Power comes in by induction, the button is a TPE overmold, the drive shaft runs through an LSR lip seal and the bottom cap seals on an O-ring. 15 parts, including the charger. Design for manufacturing: - The handle is one molded tube, closed at the top. Its bore widens towards the open bottom at 0.8 degrees, so one long core pulls straight out. - The TPE button is overmolded over a window in the shell, so the button is part of the seal: no gap and no separate gasket. - O-ring sized for 20% squeeze: a 2.0 mm cord in a 1.6 mm gland on the bottom-cap spigot. - No charging contacts: the coil in the cap sits 3.4 mm above the coil in the charger, around a locating post. - Motor, 14500 cell and board slide in from the bottom before the cap goes on. Checked in CAD: - 0.000 mm3 interference across 25 part pairs, including the O-ring, lip seal and shaft. A bristle-tuft clash was found and fixed: the tufts now sit in 2 mm holes in the head. - O-ring squeeze 20%, and the lip seal sits right on the 3.6 mm shaft. - Bore draft 0.8 degrees along the handle and 3 degrees near the top. Included: hero render, exploded view, close-up section of the shaft seal, GA drawing, annotated section and three colourways (Arctic, Onyx, Blush).
dfm consumer-electronics waterproof overmolding toothbrush