Raspberry Pi Model B Case

in Gadgets Design held by Kysar
Contest Closed
Need a case designed for Raspberry Pi model B.

Needs to be sleek and simplistic design in a couple different materials.
Contact for specifications on what is needed.
  1. SolidWorks


No Entries Submitted Yet.


No Comments Submitted Yet.

Similar Contests on Cad Crowd

Drip tray for catering
I have a working modle made fro a milk carton. Would like to get a design to to make it a bit more professional than a milk carton. Also to more extactly design a repeatable and better scales prototype with a smaple of two.
iPad Mini slider case
We're looking to have a "case" or more of a "mount" designed for an iPad mini that we will be able to install (with various fabrication depending on the application) into the dash of a vehicle. In our opinion, the iPad will be held in with magnets that we will install post-printing. So there will need to be spaces designed onto the edge to allow for magnet application. Magnets will be 7.5mmx7.5mmx1mm and there should be enough mounting spaces for at least 10 of them. There will need to be a space for the lightning connector to mount (can be glued into place post-printing). Due to the lighting connector being permanently affixed, this is why the ipad will need to slide into place, so to mount itself on the connector. We have photos of a similar product attached to this listing.
Accessory Clip for Glasses
I'm looking to create a series of fun accessories that can clip to the front of glasses or sunglasses. In this first design, the priority deliverable is the clip system to attach to the glasses. I am envisioning something like one or two S clip fasteners that would attach to either the nose bridge or each lens’ frame. The fastener would work similar to the way a money clip can be flexibly opened to insert cash and then returns to a snug resting position. See attached rough illustration for what I am envisioning. I am open to alternative fastener designs when the designer proposes a better system for connecting the accessory to the glasses. I am hoping that the fastener can work with both thicker plastic glasses, as well as thinner wire frame glasses. The accessory I would like to develop in this contest is a unicorn horn. It should be connected in the design to the fastener, so the end design is one, single piece.