4-to-Score GiantBlind

Design an electrical roller door using neoprene or similar material for door. Roller at top.

This is about a first product draft, which shall later be turned into a production ready design. I need an enclosure for a custom made electronic part. The rough form-factor should be similar to a navigation system (see attached files) with a display in front and parallel enclosure boundaries, slightly rounded edges. The display is 4.3 inches wide (see technical details attached) and should be included in the rendering. The enclosure should be 4 cm deep. As a bonus, the display shows attached bar diagram. At the back, there should be the possibility for a DIN rail mount, top hat rail EN 50022 – 35 × 7.5 but also for direct wall mount using screws or mounting to a bar with cable ties. At the front left side of the enclosure, I need a C14 inlet to add a power cable and a Schuko socket: https://en.wikipedia.org/wiki/Schuko or CEE 7/3 socket. See attached figure of the design. The material should be dark grey with a bit reflective surface. Please add our logo to the upper left corner of the front, below the display. If it fits optically, it could glow a bit in green.

We are building a WiFi enabled irrigation unit and need a prototype 3D design that we will print. Here is our company www.h2lo.co I have included these photos just to show what the slot on the bottom will look like for the consumer to attach wires to the sprinkler relay. http://rayshobby.net/wordpress/wp-content/uploads/2013/03/IMG_2424-300x200.jpg http://rayshobby.net/wordpress/wp-content/uploads/2013/03/IMG_2425-300x200.jpg http://rayshobby.net/wordpress/wp-content/uploads/2013/03/IMG_2426-300x200.jpg This design will encase a PCB board with a relay.

I need a unique, rugged quadcopter UAV design,analysis and all necessary fabrication details for production in large quantities.The quadcopter should have a high endurance similar to the Microdrones Md4-1000 LINK: (http://www.microdrones.com/products/md4-1000/md4-1000-key-information.php#what) The quadcopter should be modular in nature like the Aeryon Scout LINK: Scout(http://ww1.prweb.com/prfiles/2010/09/01/3259734/MG1969.JPG) NEEDS: good aesthetic design,analysis along with all production details, modular nature, Materials used, Sourcing details, Bill of materials(BOM)

I want a pitch fork for scooping waste and a bucket for containment. It is crucial that both components are constructed without any sharp edges to ensure safety and user-friendliness. To guide the design process, I have provided reference images that depict the desired appearance and functionality. The pitch fork should have a length of 33 inches and a 7-inch base. The bucket should closely resemble the reference image, with dimensions of 14 inches in width and 13 inches in depth. Additionally, the bucket should incorporate a ring on the back side to securely hold bags without causing any tearing or damage.I intend to incorporate a detectable bag holder onto the bucket stick, designed to securely hold a roll of 10 small disposable pop bags. A rubber bag should be included on the bucket to securely hold the bags in place once they are applied. It is important to create the product as a single, durable plastic piece to ensure its longevity and usability. Furthermore, I would like my logo to be prominently featured on the product, adding a personalized touch to the design. Although the reference images will serve as a starting point, I anticipate that minor modifications will be required to enhance uniqueness and optimize functionality. Ultimately, I am looking to obtain the STEP. file format for this product. Thank you for considering my request, and I look forward to collaborating with y'all on this.